Personnel Qualification - WIKA Mensor CPC2000 Manual De Instrucciones

3. Safety
▶
Do not use the instrument if it is damaged. Before using the instrument,
check that there are no cracks on the case or any missing plastic parts.
▶
Select the proper function and correct measuring range for the
measurement.
▶
Always operate the instrument within the defined pressure range.
▶
Do not use the instrument if it is not working properly. The instrument
protection might be compromised. If in doubt, have the instrument checked.
▶
Before starting the pressure measurement, ensure that the low-pressure
controller has been switched to a depressurised state and the test item is
correctly connected.
▶
Only use the accessories specified and authorised by WIKA.
Any use beyond or different to the intended use is considered as improper use.
Do not use this instrument in safety or emergency stop devices.
3.4

Personnel qualification

WARNING!
Risk of injury should qualification be insufficient
Improper handling can result in considerable injury and damage to equipment.
▶
The activities described in these operating instructions may only be carried
out by skilled personnel who have the qualifications described below.
Skilled personnel
Skilled personnel, authorised by the operator, are understood to be personnel who,
based on their technical training, knowledge of measurement and control technology and
on their experience and knowledge of country-specific regulations, current standards and
directives, are capable of carrying out the work described and independently recognising
potential hazards.
WIKA operating instructions, model CPC2000
EN
9