WIKA Mensor CPC2000 Manual De Instrucciones página 32

7. Interface
Command
:ats <1 ... 10000>
EN
Interface output
:o <0 | 1>
Control mode
:pa <-110 ... 110>
:pd
:pr <-1100 ... 11000>
:ps <-10 ... 110>
:pu
:saz<0 | 1>
:sbr<0 ... 1>
:sbu<0 ... 1>
:sci<n | u | r>
sdb <0 ... 100>
32
Answer function
Start delay (phase 2)
1 ... 10000 --> time in seconds
Output status information via interface
0 --> Off
1 --> On
Increase the target pressure specification by x percent
-110 ... +110 --> change in target pressure specification in %
Decrease target pressure specification by currently set step size in %
(Step DOWN).
Adjust the current working and measuring ranges -1,100 ... +11,000
--> new measuring range in 0.01 % FS
Percentage target pressure specification -10 ... +110 --> target
pressure specification in %
Increase target pressure specification by currently set step size in %
(Step UP).
Set auto zero (in Measure and Control modes)
0 --> Off
1 --> On
Set baud rate RS-232
0 --> 1200
1 --> 2400
2 --> 4800
3 --> 9600
4 --> 14400
Set baud rate RS-232
0 --> 1200
1 --> 2400
2 --> 4800
3 --> 9600
4 --> 14400
Select active interface
Set communication interface
n --> Interface off
u --> USB active
r --> RS-232 active
Display brightness
0 ... 100 --> brightness in %
5 --> 19200
6 --> 28800
7 --> 38400
8 --> 56000
9 --> 57600
5 --> 19200
6 --> 28800
7 --> 38400
8 --> 56000
9 --> 57600
WIKA operating instructions, model CPC2000