SICK WI130 Manual De Instrucciones página 48

OPERATING INSTRUCTIONS
6.8 Teach-in Lnth mode
en
48 O P E R A T I N G I N S T R U C T I O N S | Evaluation unit WI130
Pin on RUN.
SET RUN
The threshold flashes and the display
reverts to the initial setting.
This can only be set in Lnth mode. Size and width of an object can be determined.
NOTE
Not shown in Teach-in mode unless Lnth mode is selected.
NOTE
The exact size cannot be measured when teaching in using Lnth mode.
Pin on SET.
SET RUN
SET: Press the teach-in button.
L n t h S E t
IN: Press the teach-in button.
L n t h I n
L n t h g o o d
Pin on RUN.
SET RUN
The upper limit flashes and the display
reverts to the initial setting.
Is set to the threshold –10 % of the
received light.
Through-beam type SET: Press the teach-in
button with no object in the beam path
and the sender and receiver opposite one
another.
IN: Press the teach-in button with an object
present.
8020148.1HRJ/2023-02-08 | SICK
Subject to change without notice