Publicidad
Idiomas disponibles
Idiomas disponibles
1/2" IMPACT WRENCH KIT
Operator's Manual
SPECIFICATIONS
• Model: ------------------------ GIW3075K
• Rated Power: ----------------- 120 V~/ 60Hz, 7.5Amp
• No-Load Speed: -------------- 0-2100 RPM
• Impacts Per Minute: ---------- 0-2700 IPM
• Maximum Torque: ------------ 220 ft-lbs
• Square Drive: ----------------- 1/2" (13mm)
• Net Weight: -------------------- 7 Lbs
Includes: 4 Sockets (11/16", 3/4", 13/16", 7/8"), and Storage Case.
WARNING:
operator's manual before operating this tool. Save this manual for future reference.
Toll-Free Help Line: 1-888-552-8665
WeAR YOuR
SAfeTY GLASSeS
fOReSIGHT IS BeTTeR
THAN NO SIGHT
Look for this symbol to point out important safety
precautions. It means attention!!! Your safety is
involved.
GENERAL SAFETY RULES
WARNING:
other construction activities contains chemicals known to cause cancer, birth defects or
other reproductive harm. Some examples of these chemicals are:
• Lead from lead-based paints.
• Crystalline silica from bricks and cement and other masonry products.
• Arsenic and chromium from chemically treated lumber.
Your risk from these exposures varies, depending on how often you do this type of work. To reduce your exposure
to these chemicals: work in a well ventilated area, and work with approved safety equipment, such as those dust
masks that are specially designed to filter out microscopic particles.
WARNING:
instructions before using this equipment. Failure to follow all instructions listed below
may result in electric shock, fire and/or serious personal injury.
1/2" Impact Wrench Kit
Operator's Manual
T
o reduce the risk of injury, user must read and understand this
WARNING:
objects being thrown into your eyes, which can result in severe eye damage.
Before beginning tool operation, always wear safety goggles or safety glasses
with side shields and a full face shield when needed. We recommend Wide
Vision Safety Mask for use over eyeglasses or standard safety glasses with side
shields. Always wear eye protection which is marked to comply with ANSI Z87.1.
Some dust created by power sanding, sawing, grinding, drilling, and
Read and understand all warnings, cautions and operating
SAVE THESE INSTRUCTIONS
The Operation of any power tool can result in foreign
GIW3075K
Publicidad
