Publicidad
Idiomas disponibles
Idiomas disponibles
28 OPERATION
Control Panel
1
1 Encendido/Apagado (Power) Button
Press to turn the dryer Encendido(On). Press again
to turn the dryer Apagado(off).
NOTE
Pressing the Encendido/Apagado (Power)
button during a cycle will cancel that cycle and
any load settings will be lost.
2 Cycle Selector Knob
Turn this knob to select the desired cycle. Once the
desired cycle has been selected, the standard presets
are shown in the display. On Secado Manual (Manual
Dry) cycles, these settings can be adjusted using the
cycle modifier buttons any time before starting the
cycle.
3 Inicio/Pausa(Start/Pause) Button
Press this button to start the selected cycle. If the
dryer is running, use this button to pause the cycle
without losing the current settings.
NOTE
If you do not press the Inicio/Pausa(Start/Pause)
button to resume a cycle within 60 minutes, the
dryer turns off automatically.
4 Time and Status Display
The display shows the settings, estimated time
remaining, options, and status messages for the
dryer.
2
3
4
6
5 Más Tiempo/Menos Tiempo (More Time/Less Time)
Use these buttons with the Tiempo de Secado (Time
Dry) and other Secado Manual (Manual Dry) cycles to
adjust the drying time. Press the Más Tiempo (More
Time) button to increase the selected manual cycle
time by 1 minute; press the Menos Tiempo (Less
Time) button to decrease the cycle time by 1 minute.
6 Cycle Modifier Buttons
Use these buttons to select the desired cycle settings
for the selected cycle. The current settings are shown
in the display. Press the button for that modifier to
select other settings.
7 Cycle Option Buttons
The option buttons allow you to select additional cycle
options. Certain buttons also allow you to activate
special functions by pressing and holding the button
for 3 seconds.
5
7
Publicidad
