LG DT22WTG Manual Del Propietário página 41

Problem
Lint on clothes
Excess static in clothes
after drying
Clothes have damp
spots after a Sensor de
Secado (Sensor Dry)
cycle.
Possible Cause
Excess static in clothes.
Dryer is overloaded.
Tissue, paper, etc., left in pockets.
Fabric softener is not used or
used incorrectly.
Clothes dried too long
(overdried).
Drying synthetics, permanent
press, or synthetic blends.
Very large load or very small load.
Single large item such as a
blanket or comforter.
TROUBLESHOOTING
Solutions
Use a fabric softener to reduce static
electricity. Be sure to follow the
manufacturer's instructions. Overdrying
a load of laundry can cause a buildup of
static electricity. Adjust settings and use
a shorter drying time, or use Sensor de
Secado (Sensor Dry) cycles.
Divide extra large loads into smaller loads
for drying.
Check pockets thoroughly before washing
and drying clothes.
Use a fabric softener or the STATIC
SHIELD option, if equipped, to reduce
static electricity. Be sure to follow the
manufacturer's instructions.
Overdrying a load of laundry can cause a
buildup of static electricity. Adjust settings
and use a shorter drying time, or use
Secado Manual (Manual Dry) cycles.
Select a LESS DRY setting on Secado
(Sensor Dry) cycles, if necessary.
These fabrics are naturally more prone to
static buildup. Try using fabric softener, or
use LESS DRY and/or shorter Tiempo de
Secado (Time Dry) time settings.
If items are too tightly packed or too
sparse the sensor may have trouble
reading the dryness level of the load. Use
a Tiempo de Secado (Time Dry) cycle for
very small loads.
Large, bulky items such as blankets
or comforters can sometimes wrap
themselves into a tight ball of fabric. The
outside layers will dry and register on the
sensors, while the inner core remains
damp. When drying a single bulky item, it
may help to pause the cycle once or twice
and rearrange the item to unwrap and
expose any damp areas.
To dry a few remaining damp items from
a very large load or a few damp spots
on a large item after a sensor cycle has
completed, empty the lint trap, then set
a Tiempo de Secado (Time Dry) cycle to
finish drying the item(s).
41