Publicidad
Idiomas disponibles
Idiomas disponibles
The coldest zone
The
symbol indicates the location of the coldest zone of your refrigerator, whose tempe-
•
rature is less than or equal to 4°C. The latter is located in the crisper (as shown in the diagram
on page 10).
Given that the shelves are removable, always keep the shelf, located at the edge of the cold
•
zone, in the position indicated by the
area.
Temperature indicator
To ensure that food items are properly conserved in your refrigerator, especially in the coldest
•
zone, make sure that 'OK' is displayed on the temperature display. If 'OK' does not appear, the
average temperature of the zone is too high. You need to change the refrigerator's temperature
setting to a higher position.
Whenever you change the settings, wait for the temperature inside the unit to stabilise before
•
making any further adjustments, if needed. Only change the position of the thermostat gradually
and wait at least 12 hours before checking again or changing it.
After loading the appliance with fresh food or after opening the door repeatedly (or leaving
•
it open for a prolonged period), it is normal that the word "OK" does not appear in the
temperature indicator ; wait at least 12 hours before adjusting or deciding not to adjust the
temperature.
Energy saving tips
Wait for anything cooked to cool completely before storing it (e.g. soup). Do not put hot food in
•
your appliance.
Spread the food out in various locations so that the air flow is not blocked.
•
Make sure that the food does not touch the walls of the appliance, especially the back wall.
•
In the event of a power cut, do not open the door.
•
Open the door as little as possible.
•
Do not leave the door open for a long time because hot air will enter the refrigerator and the
•
cold air inside will escape, thereby wasting energy.
Make sure there are no obstructions preventing the door from closing properly.
•
Do not set the temperature to a colder temperature than necessary.
•
32
sticker. This is to preserve the temperature in this
Incorrect setting
Correct setting
Publicidad
