Thermador Professional Pro Grand Serie Manual De Instrucciones página 13

Range model Gas zone A
All Pro Harmony® 4" (102 mm)
series
36"/48" Pro 4" (102 mm)
Grand® series
60" Pro Grand® 4" (102 mm)
series
Prior to installation 4 Prior to installation
Carry out these steps to prepare your appliance for
Prior to installation
installation.
4.1 Installing the anti-tip bracket
The range can tip forward, potentially causing injury and
damage, if the anti-tip bracket is not properly installed. Do
not operate the range without the anti-tip bracket in place.
WARNING
DANGER OF TIPPING ON RANGES
All ranges can tip and injury can result. To prevent
▶
accidental tipping of the range, attach it to the floor,
wall, or cabinet by installing the anti-tip bracket
supplied.
A child or adult can tip the range over and be killed or
▶
seriously injured. Verify that the anti-tip bracket is
securely installed. Ensure the anti-tip bracket is
engaged when the range is moved.
DO NOT operate the range without the anti-tip bracket
▶
in place. Failure to follow the instructions in this manual
can result in death or serious burns to children and
adults.
If the range is moved for cleaning, service, or any other
▶
reason, ensure that the anti-tip bracket is properly
reengaged when the range is pushed back into place. In
the event of abnormal usage (such as a person
Electric zone X
B
6" (152 mm) 5" (127 mm)
6" (152 mm) 8" (203 mm)
6" (152 mm) 8" (203 mm)
C
N/A
4" (102 mm)
4" (102 mm)
standing, sitting, or leaning on an open door), failure to
take this precaution can result in tipping of the range.
Personal injury might result from spilled hot liquids or
from the range itself.
Check for proper installation and use of anti-tip bracket.
▶
Carefully tip range forward pulling from the back to
ensure that the anti-tip bracket engages the range and
prevents tip-over. Range should not move more than 1''
(2.5 cm).
WARNING
ELECTRICAL SHOCK HAZARD
Use extreme caution when drilling holes into the wall or
▶
floor as there may be concealed electrical wires.
Identify the electrical circuits that could be affected by
▶
the installation of the anti-tip bracket, then turn off
power to these circuits.
Failure to follow these instructions may result in
▶
electrical shock or other personal injury.
Note
The hardware provided is for mounting through
¡
standard thickness wood studs. The installer is
responsible for providing hardware for other types of
mounting situations.
Contact a qualified installer or contractor to determine
¡
the proper method for drilling holes through the wall or
floor material, such as ceramic tile, hardwood or other.
The anti-tip bracket may be attached to a solid wood
¡
surface having a minimum wall thickness of ¾"
(19 mm).
The thickness of the wall or floor may require the use of
¡
longer screws, available at your local hardware store.
Prior to installation en-us
D E
N/A 2" (51 mm)
3" (76 mm) 2" (51 mm)
3" (76 mm) 1" (25 mm)
13