Descargar Imprimir esta página

BH G6745 Instrucciones De Montaje Y Utilización página 20

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 1
-Solvent based lubricants used,
- Belt is too tight.
Plug the unit into a wall socket with an
EARTH terminal. Set switch (L) to
Position [1].
ASSEMBLY INSTRUCTIONS.-
The assistance of a second person
is advisable for the assembly work.
Make sure that all of the pieces are
there, Fig.0:
(A02) Main structure; (E) Console base;
(C) Console; (C07) Lower cover; (C27)
Left upright tube cover; (C28) Right
upright tube cover; (D11) Safety key;
(E07) Bolt M8x50; (E12) Bolt M8x25;
(E14)
Bolt
M8x15;
ST4,2x8; (E28) Washer D8; Wrenches.
Follow the instructions step by step to
assemble:
1 Take the unit out of the box and
place it on the floor as shown in Fig.1.
Please do not cut packing belt (I)
before you finish assembly.
2 Pull up the upright tubes (A06),
(A07), Fig.2, and fit the screws (E07),
(E14) and the washers (E28).
3 Position the lower left cover (C27)
and
right
cover
corresponding tube as shown in Fig.3.
Fig.B
(E23)
(C28)
on
4 Take the console base (E) and
connect the terminals (D05) (D06),
Fig.4.
Place the base (E) on the upright
tubes and fit the screws (E14) and the
washers (E28).
5 Take the console (C) and connect
the terminals that come out of the
monitor with the terminals that come
out of the base (E), Fig.5.
6 Attach the console (C) using the
screws (E12), Fig.6.
7 Attach the lower cover (C07) using
the screws (E23), Fig.7.
8. Remove the packing belt (I), Fig.8.
Remove the cable (G) by loosening the
screw (E14) and the washer (C29),
Fig.9.
9. Insert the safety key (D11), Fig.10.
10 LUBRICATION.-
Screw
CAUTION: Before the first use,
apply approximately half the bottle
of lubricant in the central part and
along the entire board, and on both
sides as shown in Fig.11.
(due to different running styles, always
apply more lubrication to the area where
you place your feet during the exercise).
Once the lubricant has been applied you
should neither fold nor use the machine
for a few hours. This will allow the belt to
get well impregnated.
If you have any doubts, an illustrative
video is available on our YouTube
the
channel
(https://www.youtube.com/c/BHFitnessS
ervice/videos).
20

Publicidad

loading