Care And Cleaning - Zanussi ZWI 71000 WA Manual De Instrucciones

to . After a few minutes the door can be opened (pay
attention to the water level and temperature!).
After closing the door, it is necessary to select the pro-
gramme and options again and to press button 5.
At the end of the programme
The machine stops automatically. The light of button 5
and the light corresponding to the just finished washing
phase go off.
The light C illuminates. After a few minutes the door can
be opened.
If you have set a programme or an option that ends with
water left in the tub, the light C illuminates. The door re-
mains locked to indicate that the water must be emptied
out before opening the door. During this time, the drum
Stand by: once the programme has finished after a
few minutes the energy saving system is enabled

Care and cleaning

Warning! You must DISCONNECT the appliance
from the electricity supply, before you can carry out
any cleaning or maintenance work.
Descaling
The water we use normally contains lime. It is a good idea
to periodically use a water softening powder in the ma-
chine. Do this separately from any laundry washing, and
according to the softening powder manufacturer's instruc-
tions. This will help to prevent the formation of lime de-
posits.
External cleaning
Clean the exterior cabinet of the appliance with soap and
water only, and then dry thoroughly.
Cleaning the dispenser drawer
The washing powder and additive dispenser drawer
should be cleaned regularly.
12
continues to run at regular intervals until the water drain-
ing.
Follow the below instructions to empty out the water:
1.
Turn the programme selector dial to
2. Set the draining or spinning programme.
3. If needed, reduce the spin speed, .
4. Press button 5.
At the end of the programme, the door can be now
opened. Turn the programme selector dial to
the machine off.
Remove the laundry from the drum and carefully check
that the drum is empty. If you do not intend to carry out
another wash, close the water tap. Leave the door open to
prevent the formation of mildew and unpleasant smells.
with the pilot lights switched on. By pressing any button
the appliance will come out of the energy saving status.
Remove the drawer by
pressing the catch down-
wards and by pulling it
out. Flush it out under a
tap, to remove any traces
of accumulated powder.
Cleaning the drawer recess
.
to switch
To aid cleaning, the top
part of the additive com-
partment should be re-
moved.
Having removed the draw-
er, use a small brush to
clean the recess, ensuring
that all washing powder
residue is removed from
the upper and lower part of
the recess.
www.zanussi.com