Publicidad
Idiomas disponibles
Idiomas disponibles
Troubleshooting
Fills with the Wrong
Temperature Water
Cycle Selector
Advances Through Off
For further assistance contact Maytag Services
U.S. Customers using TTY for deaf, hearing impaired or speech impaired, call 1-800-688-2080.
• Turn both faucets on fully.
• If equipped with a temperature selector knob, be sure it is set directly on a
temperature setting and not between settings.
• Make sure temperature selection is correct.
• While the washer is filling, you may notice just hot and/or just cold water entering
the tub when cold or warm wash temperatures are selected. This is a normal
function of the automatic temperature control feature as the washer determines the
temperature of the water.
• If Auto Temperature Control (select models) is selected, cold water may feel warmer
than cold water from the tap. (See page 4).
• Make sure hoses are connected to correct faucets and inlet connections. Be sure
water supply is regulated correctly. Flush water line before filling washer.
• Check the water heater. It should be set to deliver a minimum 120° F (49° C) hot
water at the tap. Also check water heater capacity and recovery rate.
• Disconnect hoses and clean screens. Hose filter screens may be plugged.
• Extra Rinse (select models) is selected.
U.S. 1-800-688-9900 or Canada 1-800-688-2002.
SM
, Maytag Customer Assistance:
10
Publicidad
