Publicidad
Idiomas disponibles
Idiomas disponibles
Tighten blade bolt securely.
Replace the lower blade guard and blade bolt cover.
Securely tighten the blade bolt cover screw.
Raise and lower the saw head and ensure that the lower
blade guard operates properly.
WARNING:
Make sure the spindle lock button is not engaged before
reconnecting saw into power source. Never engage
spindle lock button when blade is rotating.
REMOVING / REPLACING THE THROAT PLATE
See Figure 14.
WARNING:
The throat plate must be below the miter table. If the throat
plate is too high or too low, the workpiece can catch on
the uneven edges resulting in binding which could result
in serious personal injury.
Never operate the saw without a throat plate installed.
To remove / replace:
Unplug the saw.
Remove the screws securing the throat plate.
Lift the throat plate from the saw.
To reinstall the throat plate, align the holes in the throat
plate with the holes in the saw base.
Retighten the screws, being careful not to overtighten
which can cause the throat plate to bow or bend.
ADJUSTING SUPPORT FOOT
See Figure 14.
Turn the support foot clockwise or counterclockwise depending
on the amount of support needed for making sliding cuts.
NOTE: Many of the illustrations in this manual show only
portions of the compound miter saw. This is intentional so that
we can clearly show points being made in the illustrations.
Never operate the saw without all guards securely in
place and in good operating condition.
SQUARING THE BLADE TO THE FENCE
See Figures 15 - 20.
Unplug the saw.
Pull the saw arm all the way down and engage the lock
pin to hold the saw arm in transport position.
Loosen the miter lock handle approximately one-half turn
and squeeze the detent release lever.
Rotate the miter table until the scale indicator is positioned
at 0°.
ASSEMBLY
SOCKET HEAD
SCREW(S)
MITER
FENCE
16 − English
THROAT
PLATE
SUPPORT
FOOT
SOCKET HEAD
SCREW(S)
Fig. 14
Fig. 15
Publicidad
