Ryobi TSS701 Manual Del Operador página 28

VERTICALLY CUTTING BASE MOLDING
AGAINST THE MITER FENCE
See Figure 38.
 Set the bevel angle at 0° and the miter angle at 45° to
either the left or the right. (For making 90° corners.)
 Place and secure the base molding vertically against the
fence using a spring clamp and hold the base molding
securely.
NOTE: To avoid interference between the base molding
and the motor, the molding should be placed no more than
a half-inch over the throat plate when cutting or trimming
base molding at 45° right miter angles.
 Before turning on the saw, perform a dry run of the cut-
ting operation to make sure that no problems will occur
when the cut is made.
 Grasp the saw handle firmly. Squeeze the switch trigger.
Allow several seconds for the blade to reach maximum
speed.
 Slowly lower the blade into and through the base molding.
OPERATION
BASE MOLDING
28 − English
Fig. 38
RIGHT
Fig. 39