BH FITNESS H674U Manual Del Usuario página 10

Press the ENTER key to program the
distance. Press ENTER again to
program the
START/STOP to start the exercise.
HEART RATE CONTROL
PROGRAMS.-
Use the UP▲/DOWN▼ keys to select
the H.R.C function and press ENTER.
Use the UP▲/DOWN▼ keys to select
the desired option (60%, 70% 85% or
Tag) and press the ENTER key. The
first three represent the percentage with
respect to maximum heart rate (220-
age) and the fourth is used to specify
the target heart rate manually. If you
choose Tag then you should use the
UP▲/DOWN▼ keys to select the
desired heart rate and then press
ENTER. Press START/STOP to start
the exercise. The exertion level will
adjust automatically in accordance with
the selected hart rate value. If the pulse
rate is below the target value then the
exertion setting will increase by one
level every 30 seconds until it reaches
the maximum 24. If the pulse rate is
above the target value the monitor will
give out warning beeps and reduce the
exertion settings by one level every 15
seconds until it reaches the minimum 1.
If the pulse rate still stays above the
target value for more than 30 seconds
the monitor will beep and stop in order
to protect the user.
To program time, distance, and/or
calories, go through the following
procedure: Once the heart rate program
has been selected and before pressing
the START/STOP
ENTER key to program the time limit
using the UP▲/DOWN▼ keys. Press
ENTER again to program the distance.
Press the ENTER key one last time to
program the calories.
calories. Press
key, press the
Press START/STOP
exercise. Your hands must be placed
on the pulse sensors (R) when using
these programs.
RANDOM FUNCTION.-
Use the UP▲/DOWN▼ keys to select
the RANDOM function and press
ENTER.
You will see a random program profile.
Press START/STOP
exercise. The duration of the program
graph is 10 minutes, divided into 10
minutes stages.
To program time, distance and/or
calories, go through the following
procedure: Once the program has
been selected and before pressing the
START/STOP key, press the ENTER
key to program the time using the
UP▲/DOWN▼ keys. In this case the
time will be divided into 10 stages.
Press the ENTER key to program the
distance. Press ENTER again to
program
START/STOP to start the exercise.
You can vary the exertion level during
the exercise
UP▲/DOWN▼ keys.
HAND-GRIP
MEASUREMENT INSTRUCTIONS
– USE.-
PULSE Hand-grip.
On this model the pulse rate is
measured by placing both hands on
the sensors (R), located on the
handlebar, as shown in Fig.2.
When both hands are placed on the
sensors the heart symbol on the right-
hand side of the screen, marked
PULSE, will begin to flash and after a
few seconds a heart rate reading will
be displayed.
10
to
to
the calories.
by pressing
start the
start the
Press
the
PULSE