Publicidad
Idiomas disponibles
Idiomas disponibles
Deleting the Memory
To delete the content of the memory, press soft key 12 [
then, as many times as required, press soft key 3 [
To delete all values stored in the memory, the function can be
used. Confirm by pressing soft key 12 [
Measured values or end results can be added or subtracted.
Adding Values
The following example describes the addition of areas:
Measure an area as described in section "Area Measurement" ,
see page 28.
09.06.2017
13:20:23
0.0º
185 ft
+
of the second area measurement is displayed below. To show
the end result, press the measurement button 2 [ ] once more.
Note: With a length measurement, the end result is displayed
immediately.
Subtracting Values
To subtract values, press button 11 [–]. The subsequent steps
are the same as for "Adding Values" .
Briefly pressing the On/Off/Clear button 9 [ ] will delete the
last measured value in all measuring functions.
2610049010 04-18 GLM400C.indd 33
Adding/Subtracting Values
Press the button 4 [+]. The calculated area and the
symbol "+" will be displayed.
168 ft
2
Press the measuring button 2 [ ] to start another
17 ft
2
area measurement. Measure the area as described
2
in section "Area Measurement" , see page 28. Once
the second measurement is completed, the result
Deleting Measured Values
] and
].
].
33
4/6/18 8:20 AM
Publicidad
