Descargar Imprimir esta página

Bosch SHP65CM6N Instrucciones De Instalación página 7

Publicidad

Idiomas disponibles

Idiomas disponibles

If the dishwasher is to be installed in a corner, ensure that
there is adequate clearance to open the door as shown.
3 Installation Preparation
Installation Preparation
After locating the proper place for your dishwasher, create
Installation Preparation
an opening to allow for water, drain and electrical lines on
the appropriate side.
Cut a hole within the 7 x 2.5" area shown.
1.
7"
(17.8 cm)
If the opening is made through wood, sand it smooth
with coarse sandpaper.
If the opening is made through metal, use the Edge
Protector with Power Cord clips Kit SMZEPCC1UC.
2 ½"
(6.3 cm)
ø 2 ½"
(6.3 cm)
or
Pull the drain hose out of the packaging base as shown.
2.
Set the toe panel aside for later use.
3.
Remove the hose clip at the back of the dishwasher.
4.
It can be used later to hold the drain hose inside your
cabinet.
4 Installation Procedure
Installation Procedure
Follow these instructions to install the dishwasher.
Installation Procedure
4.1 Attach Vapor Barrier
If your counter-top is made of wood or other porous
material, use the provided vapor barrier to guard your
counter-top from moisture.
Remove the vapor barrier (a clear plastic film) from the
1.
back of the unit.
Clean and dry the underside of the counter where the
2.
dishwasher will be installed.
Installation Preparation en-us
7

Publicidad

loading

Este manual también es adecuado para:

Shp65cm5n