Publicidad
Idiomas disponibles
Idiomas disponibles
en-us Installation Procedure
Peel off half of the backing.
3.
Stick the barrier in place. Do not leave a gap between
4.
the barrier and the edge of the countertop.
After it is in place, remove the other half of the backing
5.
and attach firmly.
For any under-counter wood details that do not allow
the vapor barrier to lie flat, ensure that the wood is
sealed.
4.2 Attach Water Inlet Hose
NOTICE:
Avoid cross-threading
Cross-threading will cause leaks.
▶
Teflon tape
Do not use Teflon tape; it could cause leaks and
▶
damage floors or cabinetry.
8
Attach elbow joint to the water inlet valve with the open
1.
end facing towards the direction of the sink, either to the
left or the right.
. Turn by hand and do not over tighten
.
Attach hot water line to elbow.
2.
Use two wrenches to tighten, using one to stabilize and
3.
avoid putting stress on the water inlet valve.
Publicidad
