HQ-Power HQSM10008 Manual Del Usuario página 6

Colour Selection
6.4 DMX Configuration
To set the device in DMX mode:
1. Connect a DMX cable to the DMX input of the fog/smoke machine and the DMX output of a
controller (not included).
2. Prepare your device (see above).
3. Set your DMX address using the DIP switches.
channel
1 000
010
2 000
010
3 000
010
4 000
010
5 000
010
6 000
010
7 000
010
8 000
010
Make sure that the starting address of the interconnected devices do not overlap.
•
A DMX terminator is recommended for installations where the DMX cable has to run a
•
long distance or is in an electrically noisy environment (e.g. discos). The terminator
prevents corruption of the digital control signal by electrical noise. The DMX
terminator is simply an XLR plug with a 120 Ω resistor between pins 2 and 3, which is
then plugged into the XLR output socket of the last device in the chain.
V. 01 – 12/04/2017
setting
rand
oFF
Co 1
Co 2
Co 3
Co 4
Co 5
Co 6
Co 7
Co 8
Co 9
to from
009
255
009
255
009
255
009
255
009
255
009
255
009
255
009
255
HQSM10008
random colour change
smoke output
brightness red LED
dimming from 1-100 %
brightness green LED
dimming from 1-100 %
brightness blue LED
dimming from 1-100 %
brightness red, green and blue LEDs
dimming from 1-100 %
speed colour change
from slow to fast
strobe control
from slow to fast
master control
dimming from 1-100 %
6
function
LEDs off
red
green
blue
pink
purple
orange
yellow
light blue
white
function
off
on
off
off
off
off
off
off
off
©Velleman nv