The insulation on the
–
power cord and any
extension cord, the plug
and the coupling must be
fully intact
Never touch the power
–
plug, power cord and
extension cord and
electrical plug connections
with wet hands.
WARNING
Route the power cord and
extension cord properly:
Observe the minimum
–
cross-section of the
individual cords – see
"Connecting the machine
to the power supply"
Route and mark the power
–
cord so that it cannot
become damaged and no
one is endangered –
danger of stumbling!
Use of unsuitable
–
extension cords can be
dangerous. Use only
extension cords that are
approved for outdoor use
and are correspondingly
marked and have a
sufficient cross-section
RE 232, RE 272 PLUS, RE 282 PLUS
The connector and
–
coupling of the extension
cord must be waterproof
and not lie in water
It is advisable to keep the
–
plug connection at least
60 mm above the
ground/floor, e. g. by using
a cable reel
don't let the cord rub
–
against edges or pointed
or sharp objects
don't squeeze the cord
–
under doors or windows
if cords become snarled –
–
unplug the power plug and
unsnarl the cord
Always unroll the power
–
cord from the cable drum
completely to avoid risk of
fire due to overheating.
During operation
WARNING
Never draw in fluids
–
containing solvents or
undiluted acids and
solvents (e. g., gasoline,
heating oil, paint thinner or
acetone). These
substances damage the
materials used in the
machine. The spray is
highly combustible,
explosive and poisonous.
The plug must be
disconnected
immediately if the
cord is damaged –
danger of
electrocution!
Never direct the
high-pressure jet
or water hose
against the
machine itself or
against other elec -
trical appliances
and equipment –
danger of short-
circuiting!
Never direct the
high-pressure jet
or water hose
against electrical
equipment, con -
nections and
power cords – dan -
ger of short-
circuiting!
English
41