Troubleshooting - Stihl RE 232 Manual De Instrucciones

Troubleshooting

Before working on the machine, unplug the power cord, turn off the water supply and actuate the spray gun until the pressure has
been relieved.
Fault
Motor does not run when switched on
(hums when switched on)
Motor constantly switches on and off
Engine stops
Weak, ragged, unclean jet
RE 232, RE 272 PLUS, RE 282 PLUS
Cause
Mains voltage is too low or improper
Extension cord with wrong cross-section
Extension cord is too long
Mains circuit-breaker has been tripped
Spray gun not actuated
High-pressure pump or spray attachment is
leaky
Machine switches off because the motor is
overheating
Nozzle fouled
Remedy
Check electrical connection
Check plug, cable and switch
Use an extension cord with a sufficient
cross-section, see "Connecting the
machine to the power supply"
Connect the machine without an exten -
sion cord or with a shorter one
Switch off the machine, actuate the spray
gun until water only drips out of the head,
engage the safety catch, reset the mains
circuit-breaker
Actuate spray gun when switching on the
machine
Have the machine checked by a servicing
1)
dealer
Check whether the supply voltage and
machine voltage match; let the motor cool
down for at least 5 minutes
Clean nozzle, see "Maintenance"
English
65