Mounting The Smb Cat5 Kvm Switch - Belkin OmniView SMB CAT5 Manual Del Usuario

Installation

Mounting the SMB CAT5 KVM Switch

Bracket Installation (F1DP108Aea and F1DP116Aea)
Eight- or 16-Port SMB CAT5 KVM Switches include adjustable mounting
brackets ideal for installation in 19-inch racks. The mounting brackets feature
three adjustment positions to allow you to set the SMB CAT5 KVM Switch's
face flush with the ends of the rails or to extend the SMB CAT5 KVM Switch
past the front of the rails. Please follow these simple steps to achieve the
desired adjustment.
Step 1
Determine how far you would like the SMB CAT5 KVM Switch to protrude
from the rack. Select a bracket-hole scheme.
Step 2
Attach the bracket to the side of your SMB CAT5 KVM Switch using the
Phillips screws provided. (Refer to diagram below.)
Step 3
Mount the SMB CAT5 KVM Switch to the rack-rail assembly. (Refer to
diagram below.)
NOTE: If this SMB CAT5 KVM Switch will be daisy-chained to another KVM
switch, set the BANK address prior to installing on a rack. Refer to the section in
this User Manual labeled "Connecting Multiple SMB CAT5 KVM Switches
(Daisy-Chaining)".
Your SMB CAT5 KVM Switch is now mounted securely into the bracket and
you are ready to connect the console.
1
2
3
4
5
6
7
8
13