Troubleshooting - Belkin OmniView SMB CAT5 Manual Del Usuario

Troubleshooting

My server does not boot when connected to the SMB CAT5 KVM Switch
but works fine when I connect the keyboard, video, and mouse directly to
the server.
• Make sure that the keyboard and mouse cables are connected tightly
between the Server Interface Module and the server.
• Check that the keyboard and mouse cables are not crossed.
• Check the CAT5 cable connection.
I am getting ghosting, shadowing, or fuzzy images on my monitor.
• Check that all video cables are inserted properly to the Server
Interface Module.
• Check that the monitor you are using supports the resolution and refresh-rate
setting on your server.
• Lower the video resolution of your monitor.
• Check that the cable length does not exceed 100 feet (30m).
• Check that the graphics card you are using supports the resolution and
refresh-rate setting on your server.
• Connect the monitor directly into the server you are having trouble with to see
if the problem still appears.
I am getting a black screen on my monitor.
• Check that all video cables are inserted properly.
• Check that the keyboard cable is connected and inserted properly between
the server and the Server Interface Module for the appropriate port.
• Connect your monitor directly to the server to verify that your monitor is
functioning properly.
1
2
3
4
5
6
7
8
43