Connecting Servers To The Smb Cat5 Kvm Switch - Belkin OmniView SMB CAT5 Manual Del Usuario

Installation

Connecting Servers to the SMB CAT5 KVM Switch

(PS/2 Connection):
Step 1
Make sure your server is powered off.
Step 2
Using the Belkin OmniView SMB Server Interface Module for PS/2
(F1DP101AeaAP), connect the VGA connector to the monitor port on your
server. (Refer to diagram below.)
Step 3
Connect the PS/2 mouse and then the keyboard connectors to the mouse
and keyboard ports on the server. (Refer to diagram below.)
1
2
3
4
5
6
7
8
17