Publicidad
1
1. Bolt (× 3)
1. Vis (× 3)
1. Perno (× 3)
2
1
1. Tailpipe
2. Spark arrester
1. Tube d'échappement arrière
3. Joint
1. Tubo de escape
3. Junta
3
3. Gasket
2. Pare-étincelles
2. Parachispas
Cleaning the spark arrester
WARNING
Hot exhaust system may cause burns. To
avoid burns or fires, make sure that the engine
is stopped and the exhaust system is cool be-
fore cleaning spark arrester. Do not start the
engine while cleaning the exhaust system.
1. Remove the bolts.
2. Remove the tailpipe by pulling it out of the
muffler, and then remove the gasket.
3. Tap the tailpipe lightly, and then use a wire
brush to remove any carbon deposits from
the spark arrester portion of the tailpipe and
inside of the tailpipe housing.
4. Install the gasket, and then insert the tailpipe
into the muffler and align the bolt holes.
5. Install the bolts and tighten them to the spec-
ified torque.
8-81
5B410018
Publicidad
