Publicidad
English
Technical Information
Water pressure
Recommended
Maximum
Hot water temp.
Recommended
Maximum
Max. flow rate
74527XX1, 32528XX1
Hole size in mounting surface
valves
spout
Rebris E, Rebris S
Metropol
Max. depth of mounting surface
* Please know and follow all applicable local plumbing
codes when setting the temperature on the water heater.
Installation Considerations
• For best results, Hansgrohe recommends that this unit
be installed by a licensed, professional plumber.
• Please read over these instructions thoroughly before
beginning installation. Make sure that you have all
tools and supplies needed to complete the installation.
• The hot and cold supply hoses included with this faucet
are for use with ⅜ stops. If your stops are a different
size, install new stops. Adapters are not available from
Hansgrohe.
• Models 32518XX1, 32519XX1, 74518XX1,
74519XX1 only: This faucet does not include a drain
or a pull rod.
• The drain is suitable for most, but not all, lavatory sinks
sold in the United States and Canada.
2
15 - 75 PSI (0.1 - 0.5 MPa)
145 PSI (1 MPa)
120°-140° F (48° - 60° C)*
158°F (70° C)*
1.2 GPM (5.4 L/min)
0.5 GPM (1.9 L/min)
1⅛" (30 mm)
1⅜" (34 mm)
1⅛"-1⅜" (30 mm - 34 mm)
1⅛" (30 mm)
• The drain is intended for use in a sink with an overflow.
If your sink does not have an overflow, or if this drain
is too small for the hole in your sink, please refer to
the instructions included with the sink. Some
sinks include special drain installation instructions and/
or parts. Others require the use of a specialty drain.
Hansgrohe is not respnsible for the cost of a specialty
drain.
• Keep this booklet and the receipt (or other proof of
date and place of purchase) for this product in a safe
place. The receipt is required should it be necessary to
request warranty parts.
Publicidad
