Publicidad
Idiomas disponibles
Idiomas disponibles
Installation instructions
Adjusting the oven burner air adjustment shutters
Air adjustment
shutter
All oven burners have an air adjustment shutter. The purpose of the shutter is
to regulate the flow of air to the flames. Properly adjusted flames should burn
steadily with approximately 1 in of blue cone. The flames should never extend
past the edge of the burner baffles. Even though these are preset at the factory,
they should be checked and, if needed, adjusted periodically to ensure efficient
operation.
To check and adjust the oven burner air adjustment shutters:
1.
Open the oven door.
2.
Remove the oven racks.
3.
Remove the oven floor.
4.
Turn the mode selector knob from OFF to the Bake position, and then rotate
the temperature selector knob to set the temperature from the OFF position.
5.
After the oven has lit, visually check the flames coming out of the upper and
lower burners. If adjustment is needed, carefully adjust the air adjustment
shutters.
The shutters are located at the base of the burner manifolds near the back oven
wall.
26 English
Install_DOP36P86GLS_DG68-01106D-00_EN+MES+CFR.indb 26
Air adjustment
shutter
Adjustment air shutter (Broil Burner)
1.
2.
3.
A
B
4.
5.
Locking screw
Remove 1 screw of Bracket-Sub and,
remove Bracket Sub.
Remove 1 screw (A) of Broil Burner.
Remove 4 screws (B) of Bracket Broil.
Separate Bracket Broil & Broil Burner.
Loose Locking screw of Broil Burner
and, adjust air shutter.
2020-07-01 오후 4:07:35
Publicidad
