Publicidad
Idiomas disponibles
Idiomas disponibles
Problem
• Unit will not start.
• Unit starts immediately
upon inserting battery.
• Battery pack will not charge.
• Unit shuts off abruptly.
For assistance with your product, visit our website at www.portercable.com for a list of service centers, or call the
PORTER-CABLE Customer Care Center at (888) 848-5175.
The RBRC™ Seal
The RBRC™ (Rechargeable Battery Recycling Corporation) Seal on the
Li-Ion battery (or battery pack) indicates that the costs to recycle the battery
(or battery pack) at the end of its useful life have already been paid by
PORTER-CABLE.
RBRC™ in cooperation with PORTER-CABLE and other battery users, has
established programs in the United States to facilitate the collection of spent Li-Ion
batteries. Help protect our environment and conserve natural resources by returning
the spent Li-Ion battery to an authorized PORTER-CABLE service center or to your local
retailer for recycling. You may also contact your local recycling center for information on
where to drop off the spent battery.
RBRC™ is a registered trademark of the Rechargeable Battery Recycling Corporation.
MAINTENANCE
CLEANING
With the motor running, blow dirt and dust out of all air vents with dry air. Wear safety
glasses when performing this procedure. Exterior plastic parts may be cleaned with
a damp cloth and mild detergent. Although these parts are highly solvent resistant,
NEVER use solvents.
Use only mild soap and damp cloth to clean the tool. Never let any liquid get inside the
tool; never immerse any part of the tool into a liquid.
REPLACEMENT PARTS
Use only identical replacement parts. For a parts list or to order parts, visit our service website
at www.portercable.com. You can also order parts from your nearest PORTER-CABLE Factory
Service Center or PORTER-CABLE Authorized Warranty Service Center. Or, you can call our
Customer Care Center at (888) 848-5175.
SERVICE AND REPAIRS
All quality tools will eventually require servicing and/or replacement of parts. For information
about PORTER-CABLE, its factory service centers or authorized warranty service centers, visit
our website at www.portercable.com or call our Customer Care Center at (888) 848-5175.
All repairs made by our service centers are fully guaranteed against defective material and
workmanship. We cannot guarantee repairs made or attempted by others.
You can also write to us for information at PORTER-CABLE, 4825 Highway 45 North, Jackson,
Tennessee 38305, (888) 848-5175 - Attention: Product Service. Be sure to include all of the
information shown on the nameplate of your tool (model number, type, serial number, etc.).
TROUBLESHOOTING
Possible Cause
• Battery pack not installed properly. • Check battery pack installation.
• Battery pack not charged.
• The switch has been
left in the "on" position.
• Battery pack not inserted into charger. • Insert battery pack into charger until LED lights.
• Charger not plugged tin.
• Surrounding air temperature
too hot or too cold.
• Battery pack has reached its
maximum thermal limit.
• Out of charge. ( To maximize
the life of the battery pack it is
designed to shutoff abruptly when
the charge is depleted.)
Possible Solution
• Check battery pack charging requirements.
• The switch must be moved to "off" to prevent
the tool from immediately starting
when battery is inserted.
• Plug charger into a working outlet. Refer to
"Important Charging Notes" for more details.
• Move charger and battery pack to a surrounding
air temperature of above 40 degrees F (4,5°C)
or below 105 degrees F (+40,5°C).
• Allow battery pack to cool down.
• Place on charger and allow to charge.
10
Publicidad
