Cameo ZENIT Z120 G2 Manual De Usuario página 9

STAND-ALONE USER PRESETS MODE (User Colour)
The stand-alone mode "User Presets" allows you to store five individual colour presets of overall brightness and a colour mix of R, G, B and
W etc. directly in the device. Select the "User Colour" mode as per the procedure previously described in SETTING STAND ALONE MODE and
confirm with ENTER. Use the UP and DOWN buttons to select one of the stored presets Colour 1 to Colour 5 and confirm with ENTER and
select the submenu item you want to edit (observe arrow). Confirm with ENTER. The display will show a three-digit number field and you
can use the UP and DOWN controls to set the value as required between 000 and 255. Confirm by pressing ENTER again.
------- Stand Alone ------
Auto
Static
Colour Macro
Tunable White
 User Colour
SLAVE MODE
Press MODE to access the selection menu. Using the UP and DOWN controls, select the menu item "Slave" (observe arrow) and confirm with
ENTER. You can now configure the time delay before which the signal from the master unit is processed by the slave unit (00.00–10.00s in
250 ms increments) and confirm with ENTER. Connect the slave and the master units (same model) with a DMX cable and enable one of the
standalone modes on the master unit (Auto, Static, Colour Macro, Tunable White, User Colour). The slave unit will now follow the master unit
in accordance with the configuration of the
signal delay. If there is no control signal, the display characters will flash. Flashing stops as soon as a control signal is present.
---------------- Menu ----------------
DMX Address
DMX mode
Stand Alone
 Slave
Settings
System Information
DEVICE SETTINGS (Settings)
Press MODE to access the selection menu. Using the UP and DOWN controls, select the menu item "Settings" (observe arrow) and confirm
with ENTER.
---------------- Menu ----------------
DMX Address
DMX mode
Stand Alone
Slave
 Settings
System Information
This will take you to the submenu for setting the following submenu items (selection with UP and DOWN, change value or status with UP
and DOWN, confirm with ENTER):
------- User Colour -------
 Colour 1
Colour 2
Colour 3
Colour 4
Colour 5
Colour 6
------------- Delay Time -----------
00.00s
--------- Colour 1 ---------
 Dimmer <255>
DimFine <255>
Strobe <255>
Red <255>
Green <255>
Blue <255>
White <255>
Colour Temp <255>
Zoom <255>
Zoom Fine <255>
Mode
Slave
000
–
Mode
255
User Colour
9