Bosch BSG82090 Instrucciones Para El Uso página 16

en
The brush ring must be turned and the
upholstery nozzle folded back before
inserting the combination accesories
into the accessories holder.
Figure
14
When you stop cleaning for a moment, you
can use the parking aid at the back of the
vacuum cleaner.
Slide the plastic lug on the nozzle
connector into the groove at the back of
the vacuum cleaner.
Before doing this, switch the vacuum
cleaner to "Stand by" mode (see Figure 9).
When the work is done
Figure 15
Switch the vacuum cleaner off and unplug
the power cord from the mains.
Tug the power cord and let go. The cable
then rewinds automatically.
To reactivate or deactivate the cable brake,
quickly tug the power cord.
On vacuum cleaners with an electronically
actuated cable rewind, the power cord
automatically rewinds when the machine is
unplugged at the socket.
If you do not want the power cord to
rewind completely (e.g. when changing the
plug), you can apply the cable brake by
pulling the power cord.
Figure 17
You can use the parking aid on the
underside of the appliance for
parking/transporting the vacuum cleaner.
Place the vacuum cleaner upright.
Slide the plastic lug on the floor nozzle into
the groove on the unit underside.
12
Changing the filter
Replacing the MEGAfilt
bag
Figure 17
If the dust bag change indicator lights
up brightly and uniformly when the
nozzle is lifted from the floor and the
vacuum is on its highest setting, you
should change the dust bag, even if it
is not yet full. In this case it is
essential to change the dust bag due
to the type of material it contains.
Turn the dust compartment locking lever in
the direction of the arrow to open the dust
compartment cover.
Figure 18
Seal the MEGAfilt
pulling the locking tab and then remove it.
Figure 19
Place a new MEGAfilt
in the holder and close the dust bag
compartment cover.
Caution: The dust bag compartment
!
cover will only close when the
MEGAfilt SuperTEX dust bag or textile
®
filter has been inserted.
If the dust bag change indicator
continues to light up after the dust
bag has been changed, please
check whether the nozzle, pipe or
vacuum hose are obstructed.
Cleaning the motor protection filter
The motor protection filter should be cleaned
at regular intervals by tapping it or washing it
out.
20
Figure
Open the dust compartment cover
(see figure 17).
Remove the motor protection filter in the
direction of the arrow.
Empty the motor protection filter by
tapping it.
SuperTEX dust
®
SuperTEX dust bag by
®
SuperTEX dust bag
®