Klarstein 10028327 Manual De Instrucciones página 26

• Remove the basket and then unscrew and remove the cap from the salt container.
• Before first wash, add 1 lt. of water in the salt container of your machine.
• Place the end of the funnel (supplied) into the hole and introduce about 1kg of salt.
• After filling the container , screw the cap tightly back clockwise.
• Usually, the salt warning light will be cease to be illuminated within 2-6 days after the salt container has
been filled with salt.
• Immediately after filling the salt into the salt container, a washing programme should be started Otherwise
filter system, pump or other important parts of the machine may be damaged by salty water. It is out of
warranty.
NOTE: The salt container must only be refilled when the salt warning light in the control panel comes on. De-
pending on how fully the salt dissolves, the salt warning light may still be on even though the salt container is
filled. If there are spills of the salt, a soak or a rapid program should be run to remove the excess salt.
Adjusting Salt Consumtion
Close the door, within 60 seconds after power on, press Start/Pause button and hold for 5 seconds,
the machine will enter setting mode.
Press the Start/pause button to select the proper set according to your local environment, the sets will change
in the following sequence: H1->H2->H3->H4->H5->H6.
There are 6 levels of salt consumption in all. It is recommended to select the level according to below table:
Water hardness level
°dH
1
0-5
6-11
12-17
18-22
23-34
35-45
German degree of measurement for the water hardness
1
millimol, internationel unit for water hardness
2
* Factory setting
Without any operation in five seconds, the machine will exit from set mode, the machine is into standby status.
Setting on the water
mmol/l
2
0-0.9
1.0-2.0
2.1-3.0
3.1-4.0
4.1-6.1
6.2-8.0
Disital Display stalls
softener
1
2
3
4*
5
6
H1
H2
H3
H4
H5
H6
26