Monthly Maintenance; Motor Maintenance - Tennant T3 Manual De Operador

OPERATION
9. Clean the machine with an all purpose cleaner and
damp cloth (Figure 51).
FOR SAFETY: When cleaning machine, do not
power spray or hose off machine. Electrical
malfunction may occur.
FIG. 51
10. Inspect the condition of the scrub head skirt,
replace if worn or damaged (Figure 52).
FIG. 52
11. FaST Model: Connect the FaST--PAK supply hose
to the storage plug when not in use (Figure 53).
Remove any dried concentrate from the hose
connector by soaking it in warm water.
FIG. 53
12. Recharge the batteries after a total of 30 minutes
of use or more (Figure 54). (See CHARGING
BATTERIES).
22
Home Find... Go To..
FIG. 54
MONTHLY MAINTENANCE (Every 80 hours of use)
1. Clean the battery tops to prevent corrosion (See
BATTERY MAINTENANCE).
2. Check for loose battery cable connections.
3. Inspect and clean the recovery tank cover seal
(Figure 55). Replace if damaged.
FIG. 55
4. Lubricate all pivot points and rollers with silicone
spray then coat with a water resistant grease to
maintain smooth operation.
5. Check the machine for loose nuts and bolts.
6. Check the machine for leaks.

MOTOR MAINTENANCE

Contact an Authorized Tennant Service Center for
carbon brush replacement.
Carbon Brush Replacement
Drive Transaxle Motor
Vacuum Motor
Brush Motor
WARNING: Electrical Hazard. Disconnect
Battery Cables Before Servicing Machine.
Hours
750
750
750
Tennant T3/T3+ (01- -08)