Machine Operation; Pre--Operation Checks; Operating The Machine - Tennant T3 Manual De Operador

OPERATION
ATTENTION: For Conventional Scrubbing, only
use recommended cleaning detergents. Machine
damage due to improper detergent usage will void
the manufacturer's warranty.
WARNING: Fire or Explosion Hazard.
Never Use Flammable Liquids.
FOR SAFETY: When using machine, follow mixing
and handling instructions on chemical containers.

MACHINE OPERATION

FOR SAFETY: Do not operate machine, unless
operator manual is read and understood.
WARNING: Fire Or Explosion Hazard. Never
Operate Machine In Or Near Flammable Liquids,
Vapors Or Combustible Dusts.
PRE- -OPERATION CHECKS
- Sweep and dust-mop the floor.
- Check the battery meter charge level (See
BATTERY METER).
- Check the pad/brush for wear.
- Check the squeegee blades for wear and proper
adjustment.
- Make sure the recovery tank is empty and the
float shut--off screen is installed and clean.
- Check the scrub head skirt for wear.
- For FaST Scrubbing: Check the FaST--PAK
concentrate level.
- For FaST or ec- H2O Scrubbing: Make sure the
solution tank is filled with cool clean water only.
- For FaST or ec- H2O Scrubbing: Ensure that all
conventional cleaning agents are drained and
rinsed from solution tank.

OPERATING THE MACHINE

1. Turn the main power key switch to the on ( I )
position (Figure 15).
FIG. 15
12
Home Find... Go To..
2. FaST Model: To foam scrub, press the FaST
system switch to the on ( I ) position (Figure 16).
ec- H2O model: Press the ec- -H2O system switch
to the on ( I ) position (Figure 16).
NOTE: The ec- -H2O system indicator light will not turn
on until the machine starts scrubbing.
IMPORTANT: NEVER turn the FaST/ec- -H2O system
switch on when conventional scrubbing. Conventional
cleaning detergents/restorers may cause failure to the
FaST/ec- -H2O solution system. Drain, rinse and refill
solution tank with cool clean water before operating
the FaST/ec- -H2O system.
FIG. 16
3. Lower the squeegee assembly to floor by lowering
the squeegee lift lever (Figure 17). The vacuum
motor will automatically turn on.
FIG. 17
Tennant T3/T3+ (09- -08)