Circuit Breaker / Fuses; Hour Meter; Draining Tanks; Draining Recovery Tank - Tennant T3 Manual De Operador

BRUSH ASSIST MODEL: When the discharge level
reaches the last yellow light (Figure 26), the light will
begin to flash, stop scrubbing and recharge the
batteries. If the red light appears, the scrubbing
function will shut off automatically. This protects the
batteries from total discharge. Recharge the batteries
immediately.
Stop scrubbing and recharge bat-
FIG. 26

CIRCUIT BREAKER / FUSES

The machine is equipped with a resettable circuit
breaker to protect the brush motor from damage. The
circuit breaker button is located on the control panel
(Figure 27). If the circuit breaker should trip, determine
the cause, allow the motor to cool, and then manually
reset the circuit breaker button.
The machine is also equipped with three fuses located
inside the control console: 30A Main fuse (drive
model), 5A Main fuse (brush assist model), 25A
vacuum motor fuse and 7.5A FaST Pump fuse. When
replacing a fuse never substitute a higher Amp rated
fuse than specified.
Contact an Authorized Service Center for
machine repairs.
FIG. 27
Tennant T3/T3+ (01- -08)
teries
Home Find... Go To..

HOUR METER

The hour meter records the number of total hours the
brush motor has been powered on. Use the hour
meter to determine when to perform recommended
maintenance procedures and to record service history
(Figure 28).
FIG. 28

DRAINING TANKS

The recovery tank should be drained and cleaned out
after every use. The solution tank should be cleaned
out periodically to remove any corrosion.
Transport the machine to a draining site, turn the key
off and follow the draining instructions below:
FOR SAFETY: Before leaving or servicing
machine, stop on level surface, turn off machine
and remove key.

DRAINING RECOVERY TANK

1. While holding the drain hose upward, remove the
cap and lower hose to drain (Figure 29).
FIG. 29
NOTE: When using a bucket to drain the machine, do
not use the same bucket to fill the solution tank.
OPERATION
15