Brush Motor Belt Replacement (Dual Disk Model) - Tennant T3 Manual De Operador

OPERATION
BRUSH MOTOR BELT REPLACEMENT
(DUAL DISK MODEL)
WARNING: Electrical Hazard. Disconnect
Battery Cables Before Servicing Machine.
1. Using a 13 mm wrench, disconnect the scrub
head lift arms from the scrubhead mounting
brackets as shown (Figure 67).
2. Unplug the brush motor wire connector and
disconnect the solution feed hose (Figure 68).
3. Remove the scrub head from the machine
(Figure 69).
26
FIG. 67
FIG. 68
FIG. 69
Home Find... Go To..
4. Carefully lay the scrub head bottom side up and
remove the belt cover, 10 mm wrench required
(Figure 70).
FIG. 70
5. Route the new belt as shown (Figure 71).
60 cm Dual Disk Model
FIG. 71
6. To install belt, use a socket driver ratchet with an
extension and a large flathead screwdriver as
shown. The hub driver is equipped with tool slots
(Figure 72).
FIG. 72
Tennant T3/T3+ (05- -10)