Brush And Pad Information; Machine Setup; Attaching Squeegee Assembly - Tennant T3 Manual De Operador

BRUSH AND PAD INFORMATION

For best results, use the correct brush type for the
cleaning application. The following are recommended
brushes and pads.
Polypropylene Bristle Scrub Brush (Black) --
Part No. 1016765 -- 17 in / 43 cm
Part No. 1016811 -- 20 in / 50 cm
This general purpose polypropylene bristle scrub
brush is used for scrubbing lightly compacted soilage.
This brush works well for maintaining concrete, wood
and grouted tile floors.
Soft Nylon Bristle Scrub Brush (White) - -
Part No. 1016764 -- 17 in / 43 cm
Part No. 1016810 -- 20 in / 50 cm
Recommended for cleaning coated floors without
removing finish. Cleans without scuffing.
Super Abrasive Bristle Scrub Brush (Gray) - -
Part No. 1016763 -- 17 in / 43 cm
Part No. 1016805 -- 20 in / 50 cm
Nylon fiber impregnated with abrasive grit to remove
stains and soilage. Strong action on any surface.
Performs well on buildup, grease, or tire marks.
Polishing Pad (White) - -
Used to maintain highly polished or burnished floors.
Buffing Pad (Red) - -
Used for light duty scrubbing without removing floor
finish.
Scrubbing Pad (Blue) - -
Used for medium to heavy--duty scrubbing. Removes
dirt, spills, and scuffs and leaves surface clean ready
for recoating.
Stripping Pad (Brown) - -
Used for stripping of floor finish to prepare the floor for
recoating.
Heavy Duty Stripping Pad (Black) - -
Used for aggressive stripping of heavy
finishes/sealers, or very heavy duty scrubbing.
Surface preparation pad (Maroon) -- This pad is for
very aggressive floor stripping.
Tennant T3/T3+ (05- -10)
Home Find... Go To..

MACHINE SETUP

ATTACHING SQUEEGEE ASSEMBLY

1. Park the machine on a level surface and remove
the key.
2. Lift the squeegee lift lever to the upward position
(Figure 3).
FIG. 3
3. Mount the squeegee assembly to the squeegee
pivot bracket as shown (Figure 4). Make sure the
knobs are completely seated into the slots before
securing knobs.
FIG. 4
4. Connect the vacuum hose to the squeegee
assembly. Loop the hose as shown using the hose
clip provided (Figure 5).
FIG. 5
5. Check the squeegee blades for proper adjustment
(See SQUEEGEE BLADE ADJUSTMENT).
OPERATION
9