Spin only
Separate Spin Procedure. Soap water or rinse water shall be drained out
before spinning.
Ends in
The function can be set with this program, the total time including washing
time and delaying time is 3, 6 and 9 hours.
Rinse&Spin
Use this program to obtain an extra rinse with spin.
Drum Clean
This cycle is specially set in this machine to clean the drum and tube. It applys
90 ºC high temperature sterilization to make the clothes washing more green.
When this procedure is performed, the clothes or other washing cannot be
added. When proper amount of chlorine bleaching agent is put in, the barrel
cleaning effect will be better. The customer can use this procedure regularly
according to the need.
Suppression of the acoustic signals
This is an additional buzzer function on your appliance. After deactivating
the buzzer function, the buzzer will be closed. After starting the machine,
press the "Temp." button for 3 seconds and you will hear a beep, then the
buzzer will be closed. To restore the buzzer function, press the "Temp."
button again for 3 seconds.
The setting will be kept until the next reset.
Warning: After deactivating the buzzer function, the sounds will not be activated
any more before you reset it.
Child lock
To avoid mis operation by children
Press the two button 3 sec. also to be released the function.
The 'Child lock' will lock all buttons except (off).
Cut off the power supply, the kid's protection is to be released.
If you want to change the program on child lock condition, you should unlock the
child lock first, the rotate the knob to OFF position, finally choose the program
you want.
V. 2
48