Publicidad
Idiomas disponibles
Idiomas disponibles
Anti-freeze.
If your washing machine is in the room where it can get frozen easily, please
drain the remaining water inside drain pipe and inlet pipe thoroughly.
Remove the remaining water in inlet pipe:
1. Close the tap.
2. Screw off the inlet pipe from tap and put its end into the
container.
3. Start up any procedure except single Wash or Drain
procedure. Water will be drained out of inlet pipe if any
for about 40 seconds.
4. Reconnect the inlet pipe to tap.
WARNING
To avoid burning, it shall be done after the hot wáter inside the machine cools
down.
Clean detergent box and grooves
Clean detergent drawer and grooves
1.Press down the arrow location on softener cover inside the drawer.
2. Lift the clip up and take out softener cover and wash all grooves with water.
3.Restore the softener cover and push the drawer into position.
Clean inlet filter
Inlet filter shall must be cleaned if there is not any or insufficient water in when
the tap is opened.
Clean the tap filter:
1. Close the tap.
2. Select any procedure except "Wash" or "Drain" procedure.
3. Press the button "Start/Pause" and keep the procedure
running for about 40 seconds.
4. Remove the inlet pipe from the tap
5. Use water to wash the filter
6. Reconnect the inlet pipe.
V. 2
.
.
53
Publicidad
