AERMEC EWP 181 H Manual De Instrucciones página 24

USING THE REMOTE CONTROL
LOADING BATTERIES
1
Remove the battery cover at the back
of the remote control.
2
Insert batteries in the compartment,
making sure the
polarities are correctly aligned.
• Lines will be indicated on the dis-
play when batteries are properly in-
stalled.
3
Reinstall the battery cover.
4
Press the RESET button using a thin
stick.
NOTES:
• The battery life is approximately one year in normal use.
• When you replace the batteries, always change both batteries, and make sure
they are the same type.
• If the remote control does not operate properly after replacing the batteries, press
the RESET button using a thin stick.
• If you will not be using the unit for a long time, remove the batteries from the
remote control.
HOW TO USE THE REMOTE CONTROL
Point the remote control towards the
unit's signal receiver window and
press the desired button. The unit
generates a beep when it receives
the signal.
• Make sure there is no curtain or other
object between the remote control and
the unit.
• The remote control can send signals from
up to 7 metres away.
Use two size-AAA (R03) batteries.
± —
and
E-6
Remote control
cover