WEG CFW700 Manual Del Usuario página 49

First Time Power-Up and Start-Up
Step Action/Display Indication
15
If necessary, change "P0403 – Motor
„
Rated Frequency" parameter. This
change will affect P0402.
Press the
„
16
If necessary, change "P0402 – Motor
„
Rated Speed". This change will affect
P0122 to P0131, P0133, P0134, P0135,
P0182, P0208, P0288 and P0289.
Press the
„
17
If necessary, change "P0405 – Encoder
„
Pulse Numbe r" according to the
encoder model.
Press the
„
42 | CFW700
key to the next parameter.
key to the next parameter.
key to the next parameter.
Figure 5.1 (cont.): Oriented Start-up
Step Action/Display Indication
18
If necessary, change "P0406 – Motor
„
Ventilation" parameter.
Press the key to the next parameter.
„
The parameters to come after selecting
„
P0406 may vary according to the type
of control set at P0202.
19
If necessary, change "P0408 – Run
„
Self-Tuning" parameter.
Press the key to the next parameter.
„
Run the self-tuning when running in
„
VVW and vector modes.
20
Press the BACK/ESC key to end the
„
oriented start-up routine.
Press the BACK/ESC again to go back
„
to the monitoring mode.