Pick Up The Bobbin Thread - Sears Kenmore 385.11608 Manual De Instrucciones

F
• Pick Up the Bobbin Thread
1. Raise presser toot lever. Hold top thread
loosely in left hand and rotate handwhee[
toward you one complete turn,
2. Bring bobbin thread up by pulling top
thread.
If you cannot pick up bobbin thread by lotlowing steps given above, then check:
1, Is needle threaded from trent to back?
2. ls thread tangled around needle?
3. Are 3 to 4 inches of thread coming trom the shuttle?
4. ]s thread from shuttle tangled?
5. is bobbin properly installed in the bobbin case?
6. ts the machine threaded according to the instructions?
....J
3. Pull both threads under and to the back
of the presser foot, leav+ng 4 to 6 inches
of thread clear.
• Remonteduf!lde dessous
1. Remontez te pied-de-biclle. Tenez 2. Remontez le fil de canette en tu'ant sur ie
mollement le fil derriere t'atguille, de Ia fil de l'aiguilte.
maitt gallche, et tournez le volatlt d'un
tour cottlptel vers VOltS.
Si vous ne pottvez pas faire remonter fe fil de dessotts en sttivattt Ies #tapes ci+desstts, alors v#rifiez les potl,zts stttvattts:
t, Le fil est-il enfil# par le devant de l' aiguilte?
2. Le fil est-il enchev#tr# atttour de l' atguille?
3. Y-a-t+it de 3 gl4 pmtces de f!l sortant de la navette?
4. Le fiI de la navette est-iI enchev#trd?
5, La canette est-elle mtroduite correctement clans fe porte-canette?
6, L' et_lage de ia machine a-t-il _t_ fait selon Ies instructions?
3. Passez Ies det_ fils SOilSte pied-de-Oiche
et tirez-ies vers l'arrikre de 4 _ 6 po.
21