Descargar Imprimir esta página

JENN-AIR 8113P622-60 Guía De Uso Y Cuidado página 8

Publicidad

Idiomas disponibles

Idiomas disponibles

PART
PROCEDURE
Clock and
• To activate control lock for cleaning, see Locking the Control, page 14.
Control Pad
• Wash, rinse and dry. Do not use abrasive cleaning agents as they may scratch the finish.
Area
• Glass cleaners may be used if sprayed on a cloth first. DO NOT spray directly on control pad and
Control Knobs
• Remove knobs in the OFF position by pulling forward.
• Wash, rinse and dry. Do not use abrasive cleaning agents as they may scratch the finish.
• Turn on each burner to be sure the knobs have been correctly replaced.
Cooktop and
Porcelain enamel is glass fused on metal and may crack or chip with misuse. It is acid-resistant, not
Control Panel -
acid-proof.
Porcelain
All spillovers, especially acidic or sugary spillovers, should be wiped up immediately with a dry cloth.
Enamel
• When cool, wash with soapy water, rinse and dry.
• Never wipe off a warm or hot surface with a damp cloth. This may cause cracking or chipping.
• Never use oven cleaners, abrasive or caustic cleaning agents on exterior finish of range.
Side Panels,
• When cool, wash with warm, soapy water, rinse and dry. Never wipe a warm or hot surface with a damp
Storage Drawer
(select models)
• For stubborn soil, use mildly abrasive cleaning agents such as baking soda paste or Bon Ami*. Do not use
and Door
Handle - Painted
Enamel
Important: Use a dry towel or cloth to wipe up spills, especially acidic or sugary spills. Surface
may discolor or dull if soil is not immediately removed. This is especially important for
white surfaces.
Oven Window
• Avoid using excessive amounts of water which may seep under or behind glass, causing staining.
and Door - Glass
• Wash with soap and water. Rinse with clear water and dry. Glass cleaner can be used if sprayed on a cloth
• Do not use abrasive materials such as scouring pads, steel wool or powdered cleaners as they will scratch
Oven Interior
• Follow instructions on pages 5-6 to set a self-clean cycle.
Oven Racks
• Clean with warm, soapy water.
• Remove stubborn soil with cleansing powder or soap-filled scouring pad. Rinse and dry.
• Racks will permanently discolor and may not slide out smoothly if left in the oven during a self-clean
Stainless Steel
• DO NOT USE ANY CLEANING PRODUCT CONTAINING CHLORINE BLEACH.
(select models)
• DO NOT USE ABRASIVE OR ORANGE CLEANERS.
• ALWAYS WIPE WITH THE GRAIN WHEN CLEANING.
• Daily Cleaning/Light Soil –– Wipe with one of the following - soapy water, white vinegar/water solution,
• Moderate/Heavy Soil –– Wipe with one of the following - Bon Ami, Smart Cleanser, or Soft Scrub* -
• Discoloration –– Using a damp sponge or soft cloth, wipe with Cameo Stainless Steel Cleaner*. Rinse
* Brand names for cleaning products are registered trademarks of the respective manufacturers.
** To order direct, call 1-800-JENNAIR (1-800-536-6247).
display area.
cloth as this may damage the surface and may cause a steam burn.
abrasive cleaners such as steel wool pads or oven cleaners. These products will scratch or permanently
damage the surface.
first.
glass.
operation. If this occurs, wipe the rack and embossed rack supports with a small amount of vegetable oil
to restore ease of movement, then wipe off excess oil.
Formula 409 Glass and Surface Cleaner* or a similar glass cleaner - using a sponge or soft cloth.
Rinse and dry. To polish and help prevent fingerprints, follow with Stainless Steel Magic Spray*
(Part No. 20000008)**.
using a damp sponge or soft cloth. Rinse and dry. Stubborn soils may be removed with a damp Scotch-
Brite* pad; rub evenly with the grain. Rinse and dry. To restore luster and remove streaks, follow with
Stainless Steel Magic Spray*.
immediately and dry. To remove streaks and restore luster, follow with Stainless Steel Magic Spray*.
7

Publicidad

loading