Definitions
1
Loop Handle
For easy control of machine during
cutting work.
2
Carrying Ring
Connects the unit to the harness.
3
Momentary Stop Switch
Switches the engine's ignition off
and stops the engine.
4
Throttle Trigger Lockout
Must be depressed before the
throttle trigger can be activated.
5
Throttle Trigger
Controls the speed of the engine.
6
Carburetor Adjusting Screws
For tuning the carburetor.
7
Choke Lever
Eases engine starting by enriching
mixture.
8
Air Filter Cover
Covers and protects the air filter
element.
9
Cap with Spark Plug Boot
Connects the spark plug with the
ignition wire.
10 Machine Support
For resting machine on the ground.
11 Fuel Pump
Provides additional fuel feed for a
cold start.
12 Fuel Filler Cap
For closing the fuel tank.
13 Fuel Tank
For fuel and oil mixture.
FS 40, FS 40 C, FS 50, FS 50 C
14 Starter Grip
The grip of the pull starter, for
starting the engine.
15 Muffler with Spark Arresting Screen
Muffler reduces exhaust noises and
diverts exhaust gases away from
operator.
Spark arresting screen is designed
to reduce the risk of fire.
16 Mowing Head
The cutting attachment, i.e. mowing
head, for different purposes.
17 Line Limiting Blade
Metal blade on the deflector which
keeps the line of the mowing head
at the proper length.
18 Deflector
Designed to reduce the risk of injury
from foreign objects flung
backwards toward the operator by
the cutting attachment and from
contact with the cutting attachment.
19 Drive Tube
Encloses and protects the drive
shaft between the engine and
bearing housing.
Specifications
EPA / CEPA
The Emission Compliance Period
referred to on the Emissions
Compliance Label indicates the number
of operating hours for which the engine
has been shown to meet Federal
emission requirements.
Category
A = 300 hours
B = 125 hours
C = 50 hours
CARB
The Emission Compliance Period used
on the CARB-Air Index Label indicates
the terms:
Extended = 300 hours
Intermediate = 125 hours
Moderate = 50 hours
Engine
Single cylinder two-stroke engine
English
37