Storing The Machine - Stihl HT 75 Manual De Instrucciones

English
8
Slip the rotor over the starter post –
N
turn it back and forth to engage the
anchor loop (8) of the rewind spring.
Insert the screw (5) and tighten it
N
down firmly.
Go to "Tensioning the Rewind
N
Spring".
Tension the rewind spring.
Make a loop in the unwound starter
N
rope and use it to turn the rope rotor
six full revolutions
counterclockwise.
Hold the rotor steady. Pull out and
N
straighten the twisted rope.
Release the rope rotor.
N
Release the rope slowly so that it
N
winds onto the rotor.
Check spring tension:
N
72
The starter grip must be firmly
–
seated in the rope bushing. If the
grip droops to one side: Add one
more turn on rope rotor to increase
spring tension
When the starter rope is fully
–
extended it must still be possible to
rotate the rotor another half turn. If
this is not the case, the spring is
overtensioned and could break.
Take one turn of the rope off the
rotor.
Go to "Fitting the Starter Cover".
N
Fitting the Starter Cover
1
2
1
3
Push the upper mounting boss of
N
the cover (2) under the shroud (4).
Line up the tank and push the
N
bottom of the cover onto the tank.
Insert the screws (1) and tighten
N
them down firmly.

Storing the Machine

For periods of 3 months or longer
Drain and clean the fuel tank in a
N
well ventilated area.
Dispose of fuel properly in
N
accordance with local
environmental requirements.
Run the engine until the carburetor
N
is dry – this helps prevent the
carburetor diaphragms sticking
together.
Remove the saw chain and guide
N
bar, clean them and spray with
corrosion inhibiting oil.
Thoroughly clean the machine – pay
N
special attention to the cylinder fins
and air filter.
If you use a biological chain and bar
4
N
lubricant, e.g. STIHL BioPlus,
completely fill the chain oil tank.
Store the machine in a dry, high or
N
locked location, out of the reach of
children and other unauthorized
persons.
1
HT 75