After Finishing Work; Transporting; Transporting The Pole Pruner; Transporting The Battery - Stihl HTA 65 Manual De Instrucciones

English
Cutting thick branches
1
► First perform a relieving cut (2) and then a cross cut at a
distance of 20 cm (A) from the final cut (1).
► Perform a relieving cut and then finish with a cross-cut (1).

13 After Finishing Work

13.1 After Finishing Work
► Switch off the pole pruner, push retaining latch to position
and remove the battery.
► If the pole pruner is wet: Allow the pole pruner to dry.
► Clean the pole pruner.
► Clean the bar and chain.
► Loosen nut on the chain sprocket cover.
► Turn the tensioning screw two full turns counterclockwise.
The chain is now slack.
► Tighten down the nut on the chain sprocket cover.
► Fit the scabbard so that it completely covers the guide bar.
► Clean the battery.
62
a
2

14 Transporting

14.1 Transporting the Pole Pruner

► Switch off the pole pruner, push retaining latch to position
and remove the battery.
► Fit the scabbard so that it completely covers the guide bar.
► Carry the pole pruner by the shaft with the guide bar
behind you.
► Transporting the pole pruner in a vehicle: Make sure the
pole pruner cannot turn over or move.

14.2 Transporting the Battery

► Switch off the pole pruner, push retaining latch to position
and remove the battery.
► Make sure the battery is in a safe condition.
► Observe the following points when packing the battery:
– The packaging must be non-conductive.
– Make sure the battery cannot shift inside the packaging.
► Secure the packaging so that it cannot move.
The battery is subject to the requirements for the transport
of dangerous goods. The battery is classified as UN 3480
(lithium-ion batteries) and has been tested in accordance
with UN Manual of Tests and Criteria, Part III, sub-section
38.3.
For transport regulations see www.stihl.com/safety-data-
sheets

15 Storing

15.1 Storing the Pole Pruner

► Switch off the pole pruner, push retaining latch to position
and remove the battery.
► Fit the scabbard so that it completely covers the guide bar.
► Check the following points when storing the pole pruner:
13 After Finishing Work
0458-766-9921-B