Silvercrest SEM 1100 C4 Instrucciones De Uso página 12

First use
1)
2) Clean the sieve holder i, the measuring spoon a, the espresso sieve o p,
the drip grille q and the water tank 9 as described in the section "Cleaning
and Care".
3) Place the appliance on a level and heat-resistant surface. Ensure that a mains
power socket is in the vicinity.
4) Insert the drip grille q so that the float e can protrude through the hole in
the drip grille q.
5) Place the sieve holder i in the appliance by inserting the "INSERT" mark,
which is located next to the hot water shower r, into the appliance and then
turning it clockwise until the handle of the sieve holder i is facing the front
("LOCK" mark).
6) Insert the plug into a mains power socket.
7) Proceed as follows before the first use, so as to clean the internal pipelines:
Allow sufficient water for about 5 cups of espresso (about 100 ml) to flow
through the appliance. Refer to the section "Operation".
8) Let the appliance generate steam for about 30 seconds. Refer to the section
"Operation".
NOTE
► When using the appliance for the first time, it is possible that you can hear
the pump working, even though no water comes out of the appliance. If this
is the case, turn the steam control 7 in the direction of the „
that the air can escape from the pipes of the appliance (the "Steam" button
4 is pressed). After approx. 20 seconds the air will have escaped, the
noises disappear and water flows from the appliance.
Operation
Filling the water tank
NOTE
► Use only fresh drinking water for making espresso/cappuccino.
1) Remove the water tank 9 and fill it with water:
Fill it with water to at least the Min marking.
Never fill it past the Max marking.
2) Replace the water tank 9 in the machine.
SEM 1100 C4
Pull out the water tank 9 and remove the orange transport lock
from the water outlet.
", so
GB │ IE │ 9 ■