Changing Presser Foot; To Remove; To Attach; Presser Foot Types - Sears Kenmore 385.15343 Manual De Instrucciones

Changing Presser Feet
(_Lever
(_Groove
(_Pin
o To remove
Turn the handwheel toward you to raise the needle to its
highest position. Raise the presser foot.
Press the lever(_on the back of the foot holder. The
presser foot will drop off.
o To attach
Place the presser foot so that the pin (_on the foot lines
up directly below the groove (_of the foot holder.
Lower the foot holder to lock the foot in place.
Presser Foot Types
Zigzag foot
Use this foot for both straight and zigzag stitching.
For:Straight stitch (page 34)
Topstitching (page 36)
Basic zigzag (page 42)
Satin stitching (page 42)
Monogramming (page 44)
Applique (page 44)
Bar tacking (page 46)
Button sewing (page 46)
Overcasting stitch (page 48)
Multiple zigzag stitch (page 48)
Blind hem stitch (page 50)
Lace work (page 50)
J
Sliding buttonhole foot
Use this foot for manual buttonhole making. It is marked
to help you measure a buttonhole accurately.
For:Buttonhole sewing (page 54)
Zipper foot
The edge of the foot guides the zipper and keeps the
seam straight.
For:Zipper sewing (page 36)
o Hemmer foot
This special foot is for sewing a rolled hem. The curl of
the foot helps to form a hem at a constant width.
For: Rolled hem (page 38)
f
\
f
%
J
12