Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Changing Needle
(i) Needle clamp screw
(_) Pin
(_ Needle clamp
[]
Turn off the power switch.
Raise the needle to its highest position by turning
the handwheel counterclockwise,
toward you, and
lowering the presser foot°
Loosen the needle clamp screw 0 by turning it
counterclockwise°
Remove the needle from the needle clamp _).
[]
Insert a new needle into the needle clamp (_ with
the flat side to the rear°
When inserting the needle into the needle clamp (_),
push it up as far as it goes_ Tighten the needle clamp
screw (_ firmly by turning it clockwise.
[]
To check for a good needle, place the flat side of
the needle onto something flat (needle plate, glass,
etc.)
The gap between the needle and the flat surface
should be consistent. Never use a bent or blunt
needle.
A damaged needle can cause permanent snags
or runs in knits, fine silks and silk-like fabrics.
[]
[]
(-
b
[]
To Remove and Attach the Foot Holder
(_
Thumb screw
(_
Foot holder
(_
Presser bar
[]
To remove:
Remove the thumb screw (_) by
turning it counterclockwise
with a screwdriver.
[]
To attach: Match the hole in the foot holder (_ with
the threaded hole in the presser bar(_)o Tighten the
screw Q
by turning it clockwise._
Changing Presser Foot
(_) Snap-on bL_on (red button)
® Groove
(_) Pin
[]
To remove: Raise the needle to its highest position by
turning the handwheel counterclockwise.
Raise the
presser foot, and press the red button (_) on the back of
the foot holder_
[]
To attach: Place a selected presser foot so the pin (_) on
the foot lies just under the groove (_ on the foot holder_
Lower the presser bar to lock the foot in place°
[]
[]
10
Publicidad
Tabla de contenido
