Permanent Attachment To Workbench; Temporary Mounting Using Clamps - skilsaw SPT62MTC Instrucciones De Funcionamiento Y Seguridad

1609B00427 eng.qxp_SPT62MTC 5/12/15 1:53 PM Page 14
Mounting Applications

Permanent Attachment to Workbench

1. Both mounting holes 12 should be bolted se-
curely using 5/16" bolts, lock washers and hex
nuts (not included).
2. Locate and mark where the saw is to be
mounted.
3. Drill two 5/16" diameter holes through work-
bench.
4. Place the saw on the workbench, aligning holes
12 in base with holes drilled in workbench. Install
bolts, lock washers and hex nuts (Fig. 8).
FIG. 8
12
12

Temporary Mounting Using Clamps

If necessary, clamp the saw to a workbench or
table top.
• Place two or more "C" clamps on the clamping
areas 12 and secure (Fig. 9). There are clamping
areas 12 at only two corners of the saw.
• Be careful not to place clamps over the base ex-
tension clamping lever 11 (Fig. 9).
FIG. 9
11
-14-
12
12