Maintenance And Lubrication - skilsaw SPT62MTC Instrucciones De Funcionamiento Y Seguridad

1609B00427 eng.qxp_SPT62MTC 5/12/15 1:53 PM Page 18
SKILSAW Factory Service Center or Authorized
SKILSAW Service Station. Preventive mainte-
nance performed by unauthorized personnel
may result in misplacing of internal wires and
components which could cause serious hazard.
Motor Brushes
The brushes and commutator in your tool have been
engineered for many hours of dependable service.
To maintain peak efficiency of the motor, we recom-
mend every two to six months the brushes be ex-
amined. Only genuine SKILSAW replacement
brushes specially designed for your tool should be
used.
power supply before cleaning or performing any
maintenance. The tool may be cleaned most ef-
fectively with compressed air. Always wear
safety goggles when cleaning tools with com-
pressed air.
Ventilation openings and switch levers must be kept
clean and free of foreign matter. Do not attempt to
clean by inserting pointed objects through openings.
Check regularly to make sure the lower guard and
all moving parts are working properly.
Remove accumulated chips from working parts by
blowing with compressed air or wiping with a damp
cloth.

Maintenance and Lubrication

Service
We recommend that all tool
service be performed by a
Cleaning
To avoid accidents, always
disconnect the tool from the
Certain cleaning agents and
solvents
parts. Some of these are: gasoline, carbon tetra-
chloride, chlorinated cleaning solvents, ammo-
nia and household detergents that contain
ammonia.
Care of Blades
Blades can quickly become dull or lose teeth. If you
find yourself forcing the saw forward to cut instead
of just guiding it through the cut, chances are the
blade is dull or has missing teeth. Replace the blade
if any teeth are missing, loose, or dull.
Remember, blades are designed to cut, so handle
carefully.
Tool Lubrication
Your SKILSAW tool has been properly lubricated
and is ready to use. It is recommended that tools
with gears be regreased with a special gear lubri-
cant at every brush change.
Periodically lubricate moving parts with a silicone,
or light oil spray. Do not use grease because it tends
to attract and hold metal shavings.
Bearings
All bearings in this tools are lubricated with a suffi-
cient amount of high grade lubricant for the life of
the unit under normal operating conditions. No fur-
ther lubrication is required.
-18-
damage plastic