Orbegozo FDR 70 Manual De Instrucciones página 16

FDR 70
- If overheated, the safety system turns the device off. In order to restart it, unplug the unit and wait
until it cools. Once cooled, re-plug it in and press the "RESTART" button on the back of the heating
unit. To do so you will need a thin and long tool.
• Never start cleaning until the oil has cooled down.
Always unplug the fryer before cleaning.
•
Pour the oil out of the bowl using the pouring lip on the rim of the bowl.
•
Fryer body/fixed bowl
Fryer outer body – wipe with a damp cloth and dry thoroughly. Never put it in water.
•
Inner bowl – after each use, fill with hot soapy water and soak for 20 minutes. Then use a
•
non-abrasive cleaner.
Basket
After each use, remove and soak in hot soapy water for 20 minutes. Then use a stiff brush.
•
The lid and basket can alternatively be washed in your dishwasher.
•
SERVICE AND CUSTOMER CARE
If you experience any problems with the operation of the fryer, before calling for assistance refer to
the troubleshooting guide.
TROUBLESHOOTING GUIDE
Problem Possible cause
Fryer does not Fryer not plugged in
work
Fuse blown
Overheating
Oil overflowing Maximum oil level exceeded
Wet food placed in oil
The oil is old and has
deteriorated
Incorrect oil used/different oils
mixed together
Unpleasant The oil is old and has
Odour/Oil deteriorated
smokes
The oil is not suitable for deep
frying
Poor frying Incorrect temperature used
performance
Basket overloaded
Fresh chips too wet
Solution
Check fryer is plugged in
Check the fuse/circuit breaker
for your installation and replace
the fuse if necessary. If this does
not solve the problem refer to the "service"
Section.
Wait for the fryer to cool and press the "RESTART"
button on the back of the head.
Check oil level
Drain and dry food thoroughly
Replace with fresh oil
Use a good quality oil suitable for deep frying
Replace with fresh oil
Use a good quality oil suitable for deep frying
Select the correct temperature
Reduced the quantity fried
Drain and dry the chips thoroughly
16